The first time executing the app, you must click on Reset and few seconds after on Learning.
This will make the application adapt to your installation. Also you will have to fill in once the dSM circuit [0...] field and
the desired mail address to receive the notifications
- Reset Button: Clicking this will erase any parameters measured so far by the application. It must be done the
first time, and every time your installation (devices, fridges, refridgerators) change. It can be optionally used
to deal with unexpected behaviors, that may have occured by having the app run the learning process on unusual data.
- Learn Button: Clicking this will trigger the app to take into account the last 12hours of fridge operation and adapt to it, considering
it as normal behavior. Clicking this again without reseting old parameters, will result to taking the average of this calculation and the
existing parameters. It is adviced to click it only if the past 12 hours of your fridge do not contain any irregular events (plug-off, open door)
and it is important to have it clicked at least once after the device has performed a defrost, if the device is set to perform a scheduled one regularly.
- Detect Button: Clicking this will force the app to run and detect if the current behavior of the fridge is acceptable or not, comparing to the data learned
|
